Dental Handpiece Repair, Instrument Sharpening, & Surgical Repair

Dental Handpiece Repair

Basic Procedure for Highspeed Drills

1. Check piece for defects such as proper rpm,chuck,water flow,and air leaks.

2. Remove back cap and remove canister or turbine, depending on the type.

3. Clean inside thoroughly including washers.

4. Replace bearings, the bearings will be replaced in pairs to insure the highest quality repair. This will prevent the piece from failing prematurely and guarantee quality of repair.

5. The bearings will be lubricated as part of installation.

6. The "O" rings will be replaced

7. Your Dental Handpiece will be reassembled and tested for proper operation. Water flow to the burr will be checked and adjusted if necessary.

8. The chuck will be checked for proper tightness.

9. View or download our price sheet . We will call if any other charges are necessary

10. Your Dental Handpiece Repair will be packaged and shipped back to you with a complete service warranty.

Dental Handpiece Repair

Procedures for Lowspeed Drills & Surgical Drills

1. Check all functions of the handpiece.

2. Disassemble the handpiece and replace all common wearing parts. This includes pins, vanes, bearings, etc. The motor is disassembled and cleaned or rebuilt if necessary.

3. Transmission and related assemblies are cleaned and rebuilt if necessary.

4. Unit is reassembled & checked for proper operation.

If you have questions email us at info@bauerdental.org

Send us your Dental Handpiece Repairs today

Check out our Sharpening page

Look at our low prices